Embroidery hoop size chart
The Brother PR1055X stitches a maximum embroidery field of 14 x 8 inches (360 x 200 mm). Brother's ten-needle. Note the field is 14 x 8 inches, not 9.5 x 14; the 14-inch side runs left to right.
Maximum field
14 x 8 in
In millimeters
360 x 200 mm
Needles
10 (multi-needle)
Checked against the field in either orientation, with the design sizes embroiderers usually quote. A design that fills the field edge to edge needs a size down or the next machine up, because you still want room for a basting box and for nudging placement.
Read from brother-usa.com, PR1055X product page on September 24, 2026. If Brother changes the spec, that page wins over this one. The full chart of every machine and hoop we have verified, with a will-it-fit checker, is the embroidery hoop size chart.
Once you know the design fits, the embroidery pricing calculator works out what to charge from the stitch count, the blank, hooping, and digitizing.
14 x 8 inches (360 x 200 mm). That is the field the needle can reach, which is smaller than the plastic hoop, and it is the number Brother publishes on the machine's own product page.
Yes. Brother lists cap frame capability for the PR1055X, so it stitches a finished cap on the cap frame or driver sold for it. A cap front is a curved surface, so the usable design height on a cap is less than the flat field.
Only by splitting it in software and re-hooping between sections, lining them up with alignment stitches. It works, and every re-hoop is a chance for the sections to land slightly off. For paid work, quote designs that fit the field in one hooping, and price a split job for the extra handling.
No. The hoop is the plastic frame; the embroidery area is the region inside it the needle can reach, and it is always the smaller number. Every figure on this page is the field, not the frame.